4-Way Pressure Release Clamp – Wood Panel Corner Clamping System Woodworking Bracket Set

Simplify the process of gluing table tops, countertops, furniture panels, cabinet doors, and more while saving yourself from using additional clamps to keep the glue-ups straight with the DCT 4-Way Pressure Release Clamp – Wood Panel Corner Clamping System Woodworking Bracket Set – For Stock up to 6” Inches. Your stock stays flat and will not buckle during glue-up. Build any length clamp with the durable plastic bars with 12 notches for maximum adjustability to handle a variety of stock widths. This package includes 2 large notch bars, 2 small notch bars, 1 clamp assembly head, 1 clamp assembly tail, 16 assembly screws, and assembly instructions. This set is a supplemental clamp to keep your stock lined up and prevent it from popping out of the clamps. Wood required, not included.

• LARGE PANEL GLUE-UPS: The 4-Way Pressure Release Clamp – Wood Panel Corner Clamping System Woodworking Bracket Set handles stock up to 6 inches (15.2cm) thick for simplifying the process of gluing table tops, countertops, furniture panels, cabinet doors, and more and saves you from using additional clamps to keep the glue-ups straight
• 4-WAY: Stock stays flat and prevents buckling of boards during glue-up because of the equally applied pressure from all four directions (top, bottom, and both sides); Ideal for gluing table tops, shelving, veneer, laminates; Durable clamp only limited by the quality of prep and glue used
• EASY TO USE: Assembly instructions included; More convenient than lining up standard clamps and cauls; Attach notched bars to any length 1.5-inch x 1.75-inch (3.2cm x 4.4cm) board (equivalent to a 2x4 ripped in half) with provided screws, set clamp and turn handle to tighten (on large pieces, we recommend one clamp every 18 inches/45.7cm for maximum clamping efficiency); Make sure the 2x4s you use are not twisted; Drill pilot holes for the outer-most screws when attaching the pressure pads
• ADJUSTS TO YOUR PROJECT: Build any length clamp with the durable plastic bars with 12 notches for maximum adjustability to handle a variety of stock widths; Clamp can be used for boards up to 6 inches in thickness by simply adjusting the clamp width capacity with the appropriate number of notches; Turn the handle to tighten the clamp and unwind the turn handle to release pressure; Clamp has pressure pads to prevent damage to the edge of your stock
• CONTENTS: large notch bars*2, small notch bars*2, pressure pad*2, clamp assembly head*1, clamp assembly tail*1, assembly screw*16, instruction manual*1